Fitting the Shower Faucet Properly

Unlike installing a faucet for your kitchen sink or even basin you will find that this is a lot more difficult. To do this work you may need a Allen wrench, multi-head screwdriver, adjustable wrench, copper cutters, torch, fire-resistant shielding, and possibly PEX cutters and also crimpers.

In order to change the particular shower tap you will need to get access to the rear of the shower. If you are going to tile the front you can get access from the front and also get the job done that way. Since many showers do not have shutoff valves you will need to turn off your main water supply and also drain the water lines within your house.

Now take off the particular handle and the face plate from the faucet. Subsequent cut to the wall from the back or front from the shower. You may need a hole big enough to cut the old valve out and also to obtain a torch in to solder the new faucet into place. If the house is newer you might have PEX water lines, but you need to still have a copper riser to the showerhead.

You will want to solder copper tube onto the fitting that you’re likely to thread onto the faucet, if you don’t purchase the sort of valve that needs to solder right to the faucet. If it is the case be sure to take the stem out so that you do not have any troubles later coming from melting the interior parts.

As soon as you remove the old shower valve you will need to measure to ensure the brand new faucet may squeeze into place. If not you will have to cut the front from the shower to make this particular fit properly. Place Teflon around the threads before threading the brass through copper or perhaps brass by just PEX fittings onto the faucet. In some cases a shower valve is meant for a shower and a tub/shower set up. If it is the case there should be a brass plug to thread into the base of the valve.

Get the faucet firmly to a piece of wood or perhaps 2by4

Once you have the brand new fittings in position subsequently place the faucet within the location from the old faucet. Right now solder, or even crimp the water lines to the new unit. Take off the old showerhead and place a nipple and also cap to the female joint. Now shutoff anything you opened to drain the house and also turn the water to the house back on. Look for leaks. In the event that everything is excellent go and turn the water back off and also drain the house. Subsequently take off the nipple and cap and place the shower arm and also head into the female thread. Install the faceplate and also the handle and also turn the water back on. Ensure the handle is in the proper location. Otherwise, grab the handle off and rotate. If you had leakages you need to turn off the water and restore then check just before putting on the handle and faceplate.

If your old shower was a two handle style and you’re simply installing just one lever style then you will have to put in a plate that will cover the holes of the old faucet. This is marketed simply by Delta at most hardware stores.

Edmonton plumbers – go to this site for top level industry professionals to help you install your faucet properly.

This entry was posted in Plumbing and tagged , , , , , , . Bookmark the permalink.