How Much Do You Know About Scroll Saw Blades?

When it comes to choosing which type of scroll saw blade to install on your scroll saw, such as the Dewalt DW788, there are a variety of choices.The following article will discuss some of the most popular types of scroll saw blades and when to use each one.

Scroll saw blades come in two major types: pin end and plain end.
The plain end blade is a variety of blade that is flat and is kept in place by being secured between the small clamps of the scroll saw.

There is a small cross pin on either side if the pin blade.The thing that separates the two types of blades is the cross pin

The plain end blades are five inches long and will fit almost all types of scroll saws, such as the DW788.

There are several types of plain end blades:

1. Standard Tooth Blades
The teeth on a standard tooth blade are of the same size and are equally spaced apart.Standard tooth blades are available in wood and metals blades.Wood blades have bigger teeth and spaces between the teeth.As one cuts, this design is meant clear the sawdust. On the other hand, metal blades are made with teeth that are much smaller and do not have as many spaces between them. These could be noisy to some.

2. Skip-tooth Blades
Skip-tooth blades are almost the same as standard tooth blades.The thing that sets the two types of blades apart is that a skip-tooth blade has every other tooth missing.The gullet, the space between the teeth, is wider and this also helps to keep the blade cool. Most prefer these types of blades.Skip-tooth blades are also recommended for newbie scrollers.

3. Double-tooth Blades
The double-tooth blade is similar to the skip-tooth blade but the double-tooth blade has a bigger gullet between two teeth sets.
Double-tooth blades can produce a very smooth cut; however they can cut a bit slower.

4. Reverse Skip-tooth Blades
The reverse skip-tooth and skip-tooth blades are the same except that the reverse skip-tooth teeth at end of the bottom row are pointing up.The reverse skip-tooth blade will work quite well when working with plywood as it will prevent tear-out splintering at the bottom of cut.It is important to know that the blade must be set in a certain way when working with the reverse skip-tooth blade.When the saw arm is in its highest position, the blade should be set in the clamps so there are only two to three teeth that are protruding above the table top.You might need to shave a little bit off the bottom of the blade, if you cannot do this.

In case you are trying to find information about the topic of suspended ceiling accessories, then make sure to go to the site which is quoted in this passage.

This entry was posted in Do It Yourself - DIY and tagged . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *