Plumbing Tips To Save Money

If water is coming out too hot or too cold, correct plumbing tips assist individuals in solving these problems. By following good advice they can save money on otherwise expensive plumbing repairs done by professionals. Fixable problems include clogged drains, frozen pipes, and other plumbing problems.

If no hot water exists it is time to look for an unlit pilot light or one that flickers and may burn out. If it is already burnt out, relight it carefully. Check that the controls for the gas are turned on fully and the thermocouple is securely connected to the gas control unit. It should also be close to the pilot flame.

If there is hot water but not enough of it, check the thermostat settings. Try turning it up higher and see if the problem is solved. Also check if pipes are openly exposed and if so try installing insulation. Sometimes sediment has settled within the tank and can reduce hot water availability. In this case, turn off the gas and then drain it out. Inspect for any leaking faucets that will need to be repaired or replaced.

When water is too hot again check thermostat settings. Try lowering them to cooler temperatures. Another possibility is a blocked exhaust vent. In this case, clear the blockages.

Faucets that are turned on in cold weather without water coming out may be attached to frozen pipes. This can be prevented or quickly treated before further damage takes place. To prevent the initial freezing process always make sure a stead trickle is escaping from each faucet. Any exposed pipes should by heated with a heat lamp or small heater. Uninsulated pipes can also be wrapped in insulating materials like tape or foam.

If pipes are already frozen, shut the water off at the main valve. Then open the faucet that is closet to the frozen pipe. This allows the water to drain as the ice melts. In case of leaks, make the surrounding areas waterproof with coverings or containers. Slowly warm up frozen pipes from the faucet down to the direction of more frozen regions. This is done with heat lamps, heating pads, hair dryers, or propane torches.

Drain unclogging may be done after a thorough inspection of the stopper in a sink or a tub. It should be fully open and free of tangled debris or hair. If those are not the source of problems it is probably a clogged drainpipe. This is fixed simply by using a chemical drain cleaner or plunger.

Not enough, or too hot water can generally be fixed with inspection and minimal correction. Malfunctioning exhaust vents, faucets, thermostats, or pilot lights are all easily corrected. Freezing pipes are preventable or can be slowly defrosted to protect against extensive damage. This is done with heating equipment like hair dryers or wires. A clogged drain can be fixed by clearing debris or adding a chemical declogger purchased from a store. All of these plumbing tips save money.

Mister Plumber is a leading plumber Toronto and the GTA. Offering plumbing repair Toronto and plumbing services for all of your plumbing needs.

This entry was posted in Plumbing and tagged , , , , , , , , , , , , . Bookmark the permalink.

1 Response to Plumbing Tips To Save Money

  1. Ann says:

    Thanks for these tips. I'd rather to do it myself most of the time though. 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *